Auto Clear Function; Energy Saver Function; Auto Shut-Off Function - Kyocera KM-S4850W Operation Manual

CHAPTER 6 CONVENIENT FUNCTIONS

7. Auto Clear Function

The machine automatically returns to the initial state when a certain
time elapses after a copy run is complete. (The copy contrast setting,
however, does not return to the initial setting.) Before the auto clear
function is activated, copying with the same copy setting and the
same number of copies can be repeated. Also the repeat copy
function can be used for copying.
The time that elapses before the auto clear function is activated (auto
clear time) can be set to 30 seconds, 1 minute, 3 minutes, and 5
minutes by using "9 Timer Set" of the default setting. (Page 7-2)
To disable the auto clear function, set "7 Auto Clear Timer [Auto clear
time]" to "OFF". (Page 7-2)

8. Energy Saver Function

When this machine is not used for some time, press the Energy Saver
key. Only the Energy Saver indicator will light up and the machine
enters a resting state.
If the Energy Saver function is used, warm up time is shorter than the
warm up time after the main power switch is turned off (O) and then
on again. If copy operation is not used for a certain time, the machine
will automatically enter a resting state when the auto energy saver
time elapses. The factory default setting of the auto energy saver time
is 15 minutes. The auto energy saver time can be set to from 5
minutes to 45 minutes in 5 minute increments by using "9 Timer Set".
(Page 7-2)
To restart copying, press the Energy Saver key again.

9. Auto Shut-off Function

The auto shut-off function automatically turns off (O) the power if no
moving operation is performed for a certain time.
Machines generally consume much power during standby because
standby time is much longer than moving time. The function of
automatic turning off (O) the machine can reduce unnecessary power
consumption in standby or at night where power is left on by mistake,
resulting in reduction of electricity bill.
To restore from the auto shut-off, turn the main power switch on ( ❘ ).
The factory default setting of the time that elapses before
the auto shut-off is activated (auto shut-off time) is 90 minutes.
The auto shut-off time can be set to from 15 to 120 minutes in 5
minute increments by using "9 Timer Set" of the default setting.
(Page 7-2)
To disable the auto shut-off function, see "8 Auto Shut-off Time [Auto
shut-off time]" of the default setting. (Page 7-2)
6-12