Chapter 7 Management And Setting; List Of Default Setting; Machine Default - Kyocera KM-S4850W Operation Manual

CHAPTER 7 MANAGEMENT AND SETTING

The values selected when the main power switch of this machine is turned on ( ❘ ) or when the Reset key is pressed (default) can be changed.
Change each setting as needed.
The default setting items are classified into "Machine default" concerning the operation of this machine and "Copy default" concerning copy condi-
tions selected with priority depending on the details. Also these are classified based on the authorization into "User" for which settings are restricted
and "Manager" for which all settings can be accessed. To change the default setting with "Manager" authorization, a password must be entered. For
each setting, see "List of Default Setting".

1. List of Default Setting

(1) Machine default

G Items common to user/manager
Setting item
1 Paper width If this item is set to "Input width(# key)", a non-standard paper width
adjustment can be set. Use the numeric keys to enter the paper width for each
paper source.
If a non-standard paper width is entered, the APS function cannot be
used.
2 Media Type If this item is set to "ON", a paper material can be registered for each
[Paper working] paper source. Fixing temperature, copy size, and fix/unfix of roll end
will be set based on the registered paper material.
3 Media type setting If "2 Media Type [Paper working]" is set to "ON", a paper material
[Paper material can be set for each paper source including the bypass table.
adjustment] If "Custom" is selected, fixing temperature, copy size, etc. will be set
based on "@ Custom media type [Custom.pap.material]".
4 Roll end adjust- Whether paper roll end is fixed to the core of the roll or not is set. If
ment "Fix" is selected, paper will be automatically cut when paper runs out.
5 Display contrast Liquid crystal display on the operation panel is adjusted.
6 Orig.eject direct If this item is set to "Discharge to front" ["Output to front"], finished
originals will return to the front side.
If this item is set to "Discharge to back" ["Output to back"], originals
will be ejected to the rear side of the machine.
Details Selectable values Default
For each paper source Auto
Auto/Input width 8.5" to
36.2"(210 mm to 920
mm)
ON/OFF OFF
For each paper source Plain
Plain/ vellum/ film/
custom
For each paper material Unfix
Fix/Unfix (Fix for
film)
1 to 7 4
Front/rear Rear
Page
7-10
7-11
7-11
7-11
7-12
7-12
7-1