Auto Error Clear Setting - Kyocera FS-2000D Advanced Operation Manual

Using the Operation Panel

Auto Error Clear Setting

2-84
Press ? or @ to display the desired alarm.
6
The display changes as shown below.
Error
Ready
Job End
Key Confirm.
7 Press [OK]. A blinking question mark (?)
appears.
Select On or Off using ? or @.
8
9 Press [OK].
10 To exit the menu selection, press [Menu].
If an error that still allows you to continue printing occurs, the next received
data is automatically printed after a set period of time elapses. For
example, if the printer is shared over a network as a network printer and
one person causes one of the following errors, after the set period of time
elapses, the data sent from the next person is printed. The default setting
is Off (Auto Error Clear disabled). The auto clear errors are:
• Memory overflow
• Print overrun
• KPDL error
• File is not found
• RAM disk error
• CompactFlash card error
• Microdrive error
• Duplex printing is disabled
• e-MPS job is not stored
• Multiple copies are not printed
• Illegal account
• Exceeded Max. out
• Account error
• USB memory error
NOTE:
For setting the auto error clear recovery time, refer to the next
section.
1
Press [Menu].
>
Error
On
>
Error
? On
ADVANCED OPERATION GUIDE