Auto Sleep; Auto Clear - Kyocera KM-1650 Advanced Operation Manual

System Settings

Auto Sleep

Auto Clear

3-26
Use to set the machine to enter sleep mode automatically when a preset
period of time of non-use elapses.
NOTE:
This setting is displayed only on the inch specification machine.
If the Auto Sleep function causes inconvenience, it is recommended to try
a longer time period before disabling the function. If you disable this
function, it is not displayed.
1
Display the Machine default screen, refer to Access the Machine Default
Screen, on page 3-15.
2 Press or to select Auto
Sleep and press [Enter].
3
Press or to select On or Off
and press [Enter].
4
Press [Reset]. The Copier Basic screen returns.
Using Auto Clear, once a specified amount of time has passed after
copying stops (between 10 and 270 seconds), the machine returns to the
current default settings. Copies can be made continually using the same
settings (e.g. copy mode, number of copies, and exposure mode) if each
job is started before the Auto Clear function is activated.
1
Display the Machine default screen, refer to Access the Machine Default
Screen, on page 3-15.
2
Press or to select Auto Clear
and press [Enter].
3
Press or to select On or Off
and press [Enter].
4
Press [Reset]. The Copier Basic screen returns.
Machine Default:
Display Contrast
PIN # Change
Auto Sleep
Auto Sleep:
Off
On
*
Machine Default:
PIN # Change
Auto Sleep
Auto Clear
Auto Clear:
Off
On
*
ADVANCED OPERATION GUIDE
:
: On
: On
: On