Using Printer Management Utility
Setting SSL/TLS
Create a Self-Signed
Certificate.
Delete Certificate.
Set Encryption Strength
and Enable/Disable of
SSL/TLS.
Procedure
➜
Select the desired setting, and then click [Next].
If "Create a Self-Signed Certificate" was selected, the page shown in
"Creating a Self-Signed Certificate" (page 12-67) appears.
If "Delete Certificate" was selected, a confirmation page appears. Click the
[OK] button. Then, click the [OK] button to log out from Administrator
mode.
If "Set Encryption Strength and Enable/Disable of SSL/TLS." was
selected, the setup page appears. Refer to "Enabling/Disabling SSL/TLS
and Setting Encryption Strength" on page 12-70.
Select to create a certificate.
Select to delete the installed certificate. This setting appears
only when there is an installed certificate.
Select to enable or disable SSL/TLS (encryption level). This
setting appears only when there is an installed certificate.
12
12-69