Kyocera KM-4230 User Manual page 203

12
Detail – Input Tray
You can check the status of the paper drawers for this machine.
Procedure
➜ Click the "System" tab, click Detail, and then click
sub-menu that appeared.
Input Tray
Paper Size
Paper Type
Capacity
Paper
12-8
Using Printer Management Utility
Displays the paper drawer names.
"Tray 1", "Tray 2", "Tray 3", "Tray 4", "LCT", or "Bypass"
Displays the paper size that is set.
The feed direction is displayed as "LEF" or "SEF".
Standard paper sizes: A3, A4, A5, A6, B4, B5, B6, 11
×
11 14, Legal, Letter, 5.5
×
postcard, 4 6, 8K, or 16K
Non-standard paper sizes: Displayed in unit of mm
* You can specify the paper size using "A3 Wide Paper Size"
on the Administrator Settings page (page 12-36) in
Administrator mode.
Displays the paper type that is set.
Plain Paper, Thick 1, Thick 2, Thick 3, Envelope, OHP, 2nd
side Plain Paper, Thick 1 2nd-Side, Thick 2 2nd-Side, or Thick
3 2nd-Side
In addition, if the paper properties are specified, "Plain Paper"
("Specialty", etc.) is indicated.
"Single Sided Only", "High Quality Paper", or "Specialty"
Displays the capacity of the paper drawer in terms of the
maximum capacity for plain paper.
Displays the amount of paper remaining in the paper drawer
with the three levels shown below.
"Ready", "Near Empty", or "Empty"
Input Tray
×
8.5, Executive, A3 Wide*,
in the
×
17,