Setting The E-Mail Transmission - Kyocera KM-4230 User Manual

8

8.11.2 Setting the E-mail Transmission

Using Printer Management Utility or this machine's control panel, set the
mail server (SMTP server) to perform e-mail transmissions.
Using Printer Management Utility
1
Start up Printer Management Utility.
2
Enter the administrator access code, and log in to Administrator mode.
3
On the "Network" tab, click
in the sub-menu that appeared.
4
Specify settings for the following.
SMTP Server
Port Number
SMTP Connection
Timeout
Maximum E-mail Size
Binary Division
8-66
E-mail / Internet
Set the IP address of the SMTP server.
Set the port number of the SMTP server.
(Normally, use the default value of 25.)
Set the connection timeout for the SMTP server.
Set the maximum size of the transmitted mail.
Settings: "No Limitation", 100 to 3000 KB (in units of 100 KB)
Set whether to divide the e-mail into multiple e-mails (binary level)
when the e-mail size exceeds the maximum e-mail size.
However, the receiving Internet fax device may not support binary
division.
Refer to "Binary Division and Scanned File Separation" on
page 8-68.
Using the Scan Functions
FAX, and then click Send