Transmitting A Print Job To This Machine When The Copy Track Mode Is Set - Kyocera KM-4230 User Manual

11
11.1.9 Transmitting a Print Job to This Machine When the Copy
Track Mode Is Set
If the Copy Track mode is set on this machine, you must enter the access
number (password) when printing a job. For the procedure on using the
Copy Track functions to specify access numbers on this machine, refer to
the User's Manual of this machine.
Transmission procedure
1
In the printer driver setup dialog box, click the "Job Management" tab.
2
Select the
number (password) in the
00000001 and 99999998).
❍
A default access number can be registered and used rather than
entering an access number for each job.
3
Send the job.
If the entered access number is a valid number on this machine, the
job is printed and counted as a job for the account.
If an error occurs
If a print job is sent using an access number that is not available with the
Copy Track mode of this machine or if a job is sent without the
Code check box selected, proceed as follows.
1
The message "Job has been done improperly. Check the record."
appears on this machine's control panel. The job is cancelled.
2
Touch [Job Log] in this machine's control panel, touch [Print Log], and
then check the log.
11-8
Access Code check box, and then enter the access
Access Number
Job Management
box (8 digits between
Access