Air Liquide FRO PRACTIC 191/2 User Manual page 20

GB
EQUIPMENT INSTALLATION AND MAINTENANCE MUST BE PERFORMED IN COMPLIANCE
Electric shock could be fatal.
1. Never touch exposed electrical parts.
2. Switch off and disconnect the power
source before installing or opening.
3. Installation may be performed by qual-
ified persons only.
4. Installation procedure must comply
with national electricity standards and
all other relevant regulations.
Moving parts may cause injury.
1. Keep clear of hazardous areas, such as
moving rollers.
2. Keeps all doors, panels and covers
closed and in place.
WELDING MAY CAUSE FIRES OR EXPLO-
SIONS. Never weld near inflammable
materials.
1. Beware of weld flame. Always keep a
fire extinguisher close at hand.
2. Never place welding equipment on
inflammable surfaces.
3. Do not weld in closed containers.
4. Let welding equipment and material
cool before handling them.
◆ INSTALLATION AND MAINTENANCE OPERATIONS MUST BE PERFORMED BY QUALIFIED PERSONS ONLY.
◆ BEFORE INSTALLING the power source, check that the power socket satisfies ampere and voltage requirements
(see technical data table).
◆ ENSURE that the socket is protected by appropriate fuses and automatic switches.
◆ CONNECT an approved standard plug corresponding to the system socket to the power supply cable.
20
RECCOMENDATIONS OF REDUCING EMISSIONS.
WITH LOCAL SAFETY STANDARDS.
Fumes and gases may represent a safety
hazard.
Fumes and gases generated during weld-
ing may be dangerous if inhaled over a
long period of time.
1. Keep clear of fumes.
2. Ventilate welding area or wear a
breathing mask.
3. INSTALL a natural or forced air VENTI-
LATION SYSTEM in the work area.
Hot areas may cause injury.
1. Let the power source or other parts
cool before performing any mainte-
nance or servicing.
A falling power source or other equipment
may cause serious injury to persons or
damage to objects.
1. Always make use of the handle to lift
power source (applies to portable
models).
2. Use eye bolts and adequate lifting
equipment to raise the power source.
Use a protective mask with suitable glass
filter (at least NR10) to safeguard eyes.
1. Wear appropriate eye, ear and body
protection equipment.
2. Protect face, ears and neck during
welding operations. Advise other per-
sons in the vicinity to look away and
stand clear of arc rays and hot metal.
Welding wire may cause injury.
1. Do not point the torch toward any part
of the body, other persons or any type
of metal when unwinding welding
wire.
The positioning of welding equipment on
inflammable surfaces could lead to fire
outbreak or explosion.
1. Never position equipment on combus-
tible or inflammable surfaces.
2. Do not install equipment in the vicinity
of inflammable liquids.