Table of Contents
Advertisement
Quick Links
EIP-2051 Quick Start Guide
For EIP-2000 Series
English/ February 2013/ Version 1.0
1
What's in the shipping package?
The package includes the following items:
Screw Driver
CD
EIP-2051
Quick Start Guide
(This Document)
2
Installing software on your PC
Install EIP-2000 Utility:
The software is located at:
Fieldbus_CD:\EtherNetIP\remote-io\EIP-2051\Utility
1
EIP-2051 Quick Start Guide
Advertisement
Table of Contents
Related Manuals for ICP DAS USA EIP-2051
Summary of Contents for ICP DAS USA EIP-2051
- Page 1 EIP-2051 Quick Start Guide For EIP-2000 Series English/ February 2013/ Version 1.0 What’s in the shipping package? The package includes the following items: Screw Driver EIP-2051 Quick Start Guide (This Document) Installing software on your PC Install EIP-2000 Utility: The software is located at:...
-
Page 2: Eip-2051 Quick Start Guide
“Network Scan” on step 4 may not work. (Please contact with your system Administrator) Check FW/OP DIP switch if it is on OP position. Connect both the EIP-2000 and your computer to the same sub network or the same Ethernet switch, and power the EIP-2000 on. EIP-2051 Quick Start Guide... - Page 3 I/O connector – EIP-2051 20-pin Spring-type terminal connecter Description Description DI.COM DI.COM DI15 DI14 DI13 DI12 DI11 DI10 Dry.GND Dry.GND I/O Wire Connection EIP-2051 Quick Start Guide...
-
Page 4: Eip-2051 Quick Start Guide
Double click the “EIP-2000 Utility” shortcut on the desktop. Click the “Network Scan” button to search your EIP-2000 modules. Click the EIP-2051 or other EIP-2000 modules on the device list below to open the configuration dialog of EIP-2000. Each EIP-2000 module has its own configuration interface. -
Page 5: Eip-2051 Quick Start Guide
Module is about to reboot. The DI is activated. I/O status LED The DI is inactivated. For configuration of the Power On Value, Safe Value, Safe Delay for the EIP-2000. Please refer to section “4.2.2 Digital Settings” EIP-2051 Quick Start Guide... -
Page 6: Eip-2051 Quick Start Guide
How to connect with Allen-Bradley PLC？ 1. Open RSLogix 5000 and create a new project. Figure5-1. Create a new project. 2. Select the PLC type and give the project a name. Figure5-2. Set the PLC type and project name. EIP-2051 Quick Start Guide... -
Page 7: Eip-2051 Quick Start Guide
3. Create a new module in the “Ethernet” item. Figure 5-3. Create a new module. 4. Select the “ETHERNET-MODULE” below “Communications” in the Select Module window. Figure5-4. Select “ETHERNET-MODULE”. EIP-2051 Quick Start Guide... -
Page 8: Eip-2051 Quick Start Guide
5. Configure the new module parameters. The I/O length of new module must be the same with the length of EIP-2051 I/O data(Table 5-1). The input data size is 66 bytes and output data size is 2 bytes. The instance ID please refer to Table 5-2.