Innova CanOBD2&1 Owner's Manual page 97

ADDITIONAL TESTS FOR EEC-IV SYSTEMS - WIGGLE TEST
6. Select the desired Wiggle Test from the
menu displayed.
To perform the KOEO Wiggle Test:
- Highlight KOEO Wiggle Test.
- Turn ignition ON. DO NOT start
the engine.
- Press the ENTER/LD
to continue.
To perform the KOER Wiggle Test:
- Highlight KOER Wiggle Test.
- Turn the ignition ON and start the engine.
- Press the ENTER/LD
7. A "One moment please test is in
progress" message shows temporarily
on the CanOBD2&1 Scan Tool's display.
If the CanOBD2&1 Scan Tool fails
to link to the vehicle's computer, a
"Vehicle is not responding" mes-
sage shows on the CanOBD2&1
Scan Tool's display. Do the follow-
ing:
For KOEO Wiggle Test:
- Verify the ignition is ON.
- Turn the ignition OFF, wait 10 seconds, then turn back ON to
reset the computer. Press the ENTER/LD
continue.
For KOER Wiggle Test:
- Turn the engine OFF, wait 10 seconds, then turn back ON.
Press the ENTER/LD
- Press ENTER/LD
8. If the CanOBD2&1 Scan Tool was able to link to the vehicle
successfully, a "Wiggle test is active..." message shows temporarily
on the CanOBD2&1 Scan Tool's display. This is followed by a
message instructing you how to perform the test.
Press the ENTER/LD
Test at this time.
9. Wiggle, tap and move the suspected sensor or wiring.
CanOBD2&1
BE SURE to perform the added procedures in step 6, if
appropriate for your vehicle, BEFORE turning the
ignition ON.
button to continue.
button if you wish to exit the Wiggle
Ford OBD1 Systems
button
button to continue.
button to continue.
button to
95