Innova CanOBD2&1 Owner's Manual page 85

CODE RETRIEVAL PROCEDURES - ENGINE TIMING CHECK
Do not proceed to the ignition timing check procedure or the
KOER test until a PASS code (code 11 or 111) for KOEO test
is obtained.
Engine Timing Check
Before performing the KOER Self-Test, the vehicle's Ignition
Base Timing and the computer's ability to electronically control
timing advance must be checked for proper operation.
Maladjustment of ignition timing, or a problem in the advance
circuit, might generate false fault codes when performing the
KOER Self-Test that would cause the test to be invalid. Use
the following procedures to check for proper ignition timing and
to verify the computer's ability to electronically advance ignition
timing.
The
applicable to 1992 and older vehicles (excluding diesel
engines). For 1993 and newer vehicles, refer to the
vehicle's service repair manual for procedures to check
and adjust timing. DO NOT ATTEMPT TO ADJUST TIMING
ON THESE VEHICLES WITHOUT MANUFACTURER'S
SPECIFICATIONS AND PROCEDURES.
For 1992 and older vehicles, the CanOBD2&1 Scan Tool can be used in
combination with a timing light to check ignition timing and the vehicle
computers ability to advance ignition timing.
Check your vehicle thoroughly before performing any test. See
BEFORE YOU BEGIN on page 18 for details.
ALWAYS observe safety precautions whenever working on a
vehicle. Read and follow Safety Precautions on page 3 before
performing this test.
A timing light is required to perform this test.
The vehicle must pass the KOEO Test (page 79) before performing
this test.
1. Locate the vehicle's Data Link Connector (DLC). See Data Link
Connector on page 77 for connector location.
Some DLCs have a plastic cover that must be removed before
connecting the CanOBD2&1 Scan Tool's cable connector.
2. Connect the CanOBD2&1 Scan Tool
cable (with the Ford Connector Cable
Adaptor attached) to the CanOBD2&1
Scan Tool, then connect the adaptor to
the vehicle's
POWER/LINK
CanOBD2&1 Scan Tool ON, then press
ENTER/LD
CanOBD2&1
following "Timing
DLC. Press
button to turn the
button to continue.
Ford OBD1 Systems
Check" procedure
the
is only
83