Innova CanOBD2&1 Owner's Manual page 28

OBD2 Systems
CODE RETRIEVAL PROCEDURE
The CanOBD2&1 Scan Tool will
automatically re-link to the vehicle's
computer every 30 seconds to
refresh the data being retrieved.
When data is being refreshed, the
message "One moment Auto – link
in progress" is shown on the display.
This action repeats as long as the
CanOBD2&1
communicating with the vehicle's
computer.
The CanOBD2&1 Scan Tool will
display a code only if codes are
present in the vehicle's computer
memory. If no codes are present, a
"No DTC's are presently stored in
the vehicle's computer" message is
displayed.
The CanOBD2&1 Scan Tool is capable of retrieving and storing
up to 32 codes in memory, for immediate or later viewing.
8. To read the display:
Refer to DISPLAY FUNCTIONS on page 12 for a description
of display elements.
A visible
being powered through the vehicle's DLC connector.
A visible
linked to (communicating with) the vehicle's computer.
The I/M Monitor Status icons indicate the type and number of
Monitors the vehicle supports, and provide indications of the
current status of the vehicle's Monitors. A solid Monitor icon
indicates the associated Monitor has run and completed its
testing. A blinking Monitor icon indicates the associated Monitor
has not run and completed its testing.
The upper right hand corner of the
display shows the number of the
code currently being displayed, the
total number of codes retrieved, the
type of code (G = Generic; M =
Enhanced or Manufacturer specific),
and whether or not the displayed
code commanded the MIL on. If the
code being displayed is a PENDING
code, the PENDING icon is shown.
The Diagnostic Trouble Code (DTC) and related code definition
are shown in the lower section of the display.
26
Scan Tool
icon indicates that the CanOBD2&1 Scan Tool is
icon indicates that the CanOBD2&1 Scan Tool is
is
CanOBD2&1