Innova CanOBD2&1 Owner's Manual page 42

OBD2 Systems
ERASING DIAGNOSTIC TROUBLE CODES (DTCs)
The CanOBD2&1 Scan Tool must
be connected to the vehicle's DLC
to erase the codes from the
computer's memory. If you press
the ERASE
CanOBD2&1 Scan Tool is not
connected to the vehicle's DLC, the
erase instruction screen displays.
The Erase function can be performed only from the OBD2
DTC screen. The Erase function cannot be performed while
the CanOBD2&1 Scan Tool is in "enhanced" mode.
1. If not connected already, connect the
CanOBD2&1 Scan Tool to the vehicle's
DLC, and turn the ignition "On." (If the
CanOBD2&1 Scan Tool is already
connected and linked to the vehicle's
computer, proceed directly to step 4. If
not, continue to step 2.)
2. Turn the ignition ON. DO NOT start the
engine.
POWER/LINK
communication
computer.
3. Press and release the ERASE
button. A confirmation message shows
on the LCD display.
- If you are sure you want to proceed
press the ERASE
erase DTCs
computer.
- If you do not want to continue with the erase process, press the
POWER/LINK
4. If you chose to erase DTCs, a progress
screen displays while the erase function
is in progress.
If the erase was successful, a
confirmation message shows on the
display. Press the POWER/LINK
button to return to the DTC
screen.
If the erase was not successful, an
advisory message shows on the
display. Verify that the CanOBD2&1
Scan Tool is properly connected to
the vehicle's DLC and that the
ignition is on, then repeat steps 2
and 3, above.
40
button when the
Press and release
button to establish
with the
button again to
from the
button to exit the erase mode.
the
vehicle's
vehicle's
CanOBD2&1