Innova CanOBD2&1 Owner's Manual page 54

OBD2 Live Data Mode
RECORDING (CAPTURING) LIVE DATA
The CanOBD2&1 Scan Tool is capable of recording
approximately 20 frames of Live Data. Record by DTC trigger
lets you select the point in time at which you wish the
CanOBD2&1 Scan Tool to begin recording Live Data. You can
set the trigger point to record the 20 frames of data before an
event (when the DTC was set), after the event, or in the middle
(10 frames before and 10 frames after the event.
Beginning - records approximately
20 frames of Live Data after the
ENTER/LD
Middle - records approximately 10
frames of Live Data before and 10
frames after the ENTER/LD
button was pressed.
End - records approximately 20 frames of Live Data before the
ENTER/LD
6. Use the UP
desired trigger point, then press the ENTER/LD
A "One
message shows on the display.
When the CanOBD2&1 Scan Tool is
ready to record Live Data, the
"Record Live Data" screen displays.
7. Put the engine in the operating condition
where the problem manifests itself.
If necessary, drive the vehicle until you reach the vehicle speed
at which the problem occurs.
8. When the problem occurs, press and
release the ENTER/LD
All three LEDs will blink for three
seconds to indicate that Live Data is
being recorded, and a "One moment
please. . ." message shows on the
display.
When recording is complete, a
confirmation screen displays, asking
if you would like to view the
recorded data. Use the UP
DOWN
select Yes or No, as desired, then
press the ENTER/LD
If Yes is selected, the CanOBD2&1 Scan Tool enters "Playback" mode
from which you can view a frame-by-frame playback of recorded Live
Data (see LIVE DATA PLAYBACK on page 53 for details). If No is
selected, the display returns to the "Live Data View" mode.
52
button was pressed.
button was pressed.
and DOWN buttons, as necessary, to select the
moment please.
button.
buttons, as necessary, to
button.
button.
. ."
and
CanOBD2&1