Innova CanOBD2&1 Owner's Manual page 83

For 7.3L diesel engines: Press and hold accelerator until all
codes are sent (steps 7 through 9).
For 2.3L turbo engines with octane switch: Put switch in
premium position.
7. Press the ENTER/LD
8. While codes are being retrieved, a "One
moment
progress..." message shows on the
CanOBD2&1 Scan Tool's display.
As soon as the ignition is turned
"on", the vehicle's computer enters
the
sounds will be heard coming from
the engine. This is normal. It
indicates that the vehicle's computer is activating relays,
solenoids, and other components to check their operation.
WARNING: On some vehicles equipped with an Electric
Cooling Fan, the computer activates the cooling fan to
check its operation. To avoid injury, keep hands or any
part of your body a safe distance from the engine during
this test.
If the CanOBD2&1 Scan Tool fails to
link to the vehicle's computer, a
"Vehicle is not responding" message
shows on the CanOBD2&1 Scan
Tool's display. Do the following:
- Verify the ignition is ON.
- Check the cable connections at
the CanOBD2&1 Scan Tool and
at the vehicle's DLC.
- Turn the ignition OFF, wait 10 seconds, then turn back ON to
reset the computer.
- Press ENTER/LD
9. If the CanOBD2&1 Scan Tool was able to link to the vehicle
successfully a "Code retrieval was successful..." message shows
temporarily on the CanOBD2&1 Scan Tool's display followed by any
retrieved DTCs.
The CanOBD2&1 Scan Tool will
display a code only if codes are
present in the vehicle's computer
memory.
If no problems are found during the
KOEO
sends a "PASS" code (code 11 or
111) to the CanOBD2&1 Scan Tool.
CanOBD2&1
CODE RETRIEVAL PROCEDURES - KOEO TEST
button to continue.
please KOEO test
Self-Test mode.
BE SURE to perform the added procedures in step 6, if
appropriate for your vehicle, during code retrieval.
Self-Test, the
Ford OBD1 Systems
is in
Clicking
button to continue.
computer
81