Innova CanOBD2&1 Owner's Manual page 74

Chrysler/Jeep OBD1 Systems
CODE RETRIEVAL PROCEDURE
If the CanOBD2&1 Scan Tool fails
to link to the vehicle's computer, a
"Vehicle is not responding" message
shows on the CanOBD2&1 Scan
Tool's display. Do the following:
- Verify the ignition is ON.
- Check the cable connections at
the CanOBD2&1 Scan Tool and
at the vehicle's DLC.
- Turn the ignition OFF, wait 10-12 seconds, then turn back ON
to reset the computer.
- Press the ENTER/LD
6 as necessary.
7. If the CanOBD2&1 Scan Tool was able
to link to the vehicle successfully a
"Code retrieval
message shows temporarily on the
CanOBD2&1
followed by any retrieved DTCs.
The CanOBD2&1 Scan Tool will
display a code only if codes are
present in the vehicle's computer
memory. If no codes are present, a
"No DTC's are presently stored in
the vehicle's computer" message is
displayed.
8. If more than one code was retrieved
press the DTC SCROLL
necessary, to display additional codes
one at a time.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information. Use the
and
information.
9. Disconnect the CanOBD2&1 Scan Tool from the vehicle and turn
the ignition key OFF.
10. To prolong battery life, the CanOBD2&1 Scan Tool automatically
shuts "Off" after approximately three minutes of no button activity.
The DTCs retrieved will remain in the CanOBD2&1 Scan Tool's
memory, and may be viewed at any time. If the CanOBD2&1 Scan
Tool's batteries are removed, or if the CanOBD2&1 Scan Tool is re-
linked to a vehicle to retrieve codes, any prior codes in its memory
are automatically cleared.
See VIEWING DTCs IN THE CANOBD2&1 SCAN TOOL'S
MEMORY on page 13 to view DTCs stored in the CanOBD2&1
Scan Tool's memory.
72
button and repeat steps 4 through
was successful..."
Scan Tool's display
button, as
buttons, as necessary, to view the additional
CanOBD2&1