2. Press the UP
as necessary, to highlight the desired
Unit of Measure.
3. When the desired Unit of Measure
value is selected, press the ENTER/LD
button to save your changes and
return to the Setup Menu.
Exiting the MENU Mode
1. Use the UP
Menu Exit in the Setup Menu, then press the ENTER/LD
button.
If diagnostic data IS currently stored in the CanOBD2&1 Scan
Tool's memory, the stored data is shown on the display.
If diagnostic data IS NOT currently stored in the CanOBD2&1
Scan Tool's memory, the "Linking Instructions" screen is shown
on the display.
CanOBD2&1
About the CanOBD2&1 Scan Tool
ADJUSTMENTS/SETTINGS AND DTC LIBRARY
or DOWN
and DOWN
button,
buttons, as necessary, to highlight
9