Innova CanOBD2&1 Owner's Manual page 25

P0201 - Injector Circuit Malfunction, Cylinder 1
B - Body
C - Chassis
P - Powertrain
U - Network
0 - Generic
1 - Manufacturer Specific
2 - Generic
3 - Includes both Generic and Manufacturer
Specific Codes
Identifies the system where the
problem is located:
1 - Fuel and Air Metering
2 - Fuel and Air Metering (injector circuit
malfunction only)
3 - Ignition System or Misfire
4 - Auxiliary Emission Control System
5 - Vehicle Speed Control and Idle Control
System
6 - Computer Output Circuits
7 - Transmission
8 - Transmission
Identifies what section of the system
is malfunctioning
DTCs and MIL Status
When the vehicle's on-board computer detects
a failure in an emissions-related component or
system, the computer's internal diagnostic
program assigns a diagnostic trouble code
(DTC) that points to the system (and subsystem)
where the fault was found. The diagnostic
program saves the code in the computer's
memory. It records a "Freeze Frame" of conditions present when the
fault was found, and lights the Malfunction Indicator Lamp (MIL). Some
faults require detection for two trips in a row before the MIL is turned on.
The "Malfunction Indicator Lamp" (MIL) is the accepted term
used to describe the lamp on the dashboard that lights to warn
the driver that an emissions-related fault has been found.
Some manufacturers may still call this lamp a "Check Engine"
or "Service Engine Soon" light.
CanOBD2&1
DIAGNOSTIC TROUBLE CODES (DTCs)
OBD2 DTC EXAMPLE
OBD2 Systems
P 0 2 0 1
23