Innova CanOBD2&1 Owner's Manual page 56

OBD2 Live Data Mode
LIVE DATA PLAYBACK
2. If the Code Reader is not connected to
a vehicle:
With the CanOBD2&1 Scan Tool not
connected to a vehicle, press the
POWER/LINK
Link"
CanOBD2&1 Scan Tool's display.
Press the DOWN
instructions
memory.
Press the ENTER/LD
The "Select OBD System" screen
displays.
Use the UP
buttons, as necessary, to highlight
OBD2 Vehicle, then press the
ENTER/LD
shows the first DTC stored in the
CanOBD2&1 Scan Tool's memory.
Press the ENTER/LD
place the CanOBD2&1 Scan Tool in
"Live Data Playback" mode.
3. The display shows the recorded Live Data, beginning with the
"trigger" frame.
When you select Yes from the
Record Live Data confirmation
screen, the CanOBD2&1 Scan
Tool
Playback" mode, and the display
shows the recorded Live Data,
beginning with the "trigger" frame.
A vehicle usually supports several PIDs, however, only a
limited amount of PID data can be displayed on the screen at
one time. If additional PID data is available, a small arrow will
be shown on the display. Use the UP
buttons, as necessary, to scroll up or down to view all available
PID data.
When viewing recorded Live Data, look for any irregularities in
any of the PID values/signal information (LTFT %, RPM, MAP,
TEMP, etc.). If any PIDs are not within specification, or
irregularities are detected, follow the procedures in the vehicle's
service repair manual to perform additional troubleshooting and
repair.
54
button. The "To
screen shows
button for
to view
and DOWN
button. The display
enters the "Live
on the
DTCs in
button.
button to
Data
and DOWN
CanOBD2&1