Innova CanOBD2&1 Owner's Manual page 110

Toyota/Lexus OBD1 Systems
CODE RETRIEVAL PROCEDURE
1. Locate the vehicle's Data Link Connector (DLC). See Data Link
Connector (DLC) on page 106 for connection location.
Some DLCs have a plastic cover that must be removed before
connecting the CanOBD2&1 Scan Tool's cable connector.
2. Connect the CanOBD2&1 Scan Tool cable (with the Toyota
Connector Cable Adaptor attached) to the CanOBD2&1 Scan
Tool, then connect the adaptor to the vehicle's DLC. Press the
POWER/LINK
ON.
3. Turn ignition ON and start engine. Warm engine to operating
temperature. (Shut engine off after warm up).
4. When prompted by the CanOBD2&1 Scan Tool, do the following
before proceeding to step 5:
Turn ignition ON. DO NOT start the
engine.
Make sure throttle is closed.
Set gear
automatic transmissions) or "neutral"
for manual transmissions.
Turn off all accessories.
5. Press the ENTER/LD
The CanOBD2&1 Scan Tool will begin the code retrieval
process.
6. When the CanOBD2&1 Scan Tool is in
the process of retrieving codes, a "One
moment please..." message shows on
the CanOBD2&1 Scan Tool's display.
If the CanOBD2&1 Scan Tool fails
to link to the vehicle's computer a
"Vehicle is not responding" message
shows on the CanOBD2&1 Scan
Tool's display. Do the following:
- Verify the ignition is ON.
- Check the cable connections at
the CanOBD2&1 Scan Tool and
at the vehicle's DLC.
- Turn the ignition OFF, wait 10-12
seconds, then turn back ON to
reset the computer.
- Press the ENTER/LD
5 as necessary.
108
button to turn the CanOBD2&1 Scan Tool
lever in "park"
button to continue.
button and repeat steps 3 through
(for
CanOBD2&1