Innova CanOBD2&1 Owner's Manual page 47

1. Using retrieved Diagnostic Trouble Codes (DTCs) and code
definitions as a guide, and following manufacturer's repair
procedures, repair the fault or faults as instructed.
2. After the fault or faults have been repaired, connect the
CanOBD2&1 Scan Tool to the vehicle's DLC and erase the code or
codes from the vehicle's computer memory.
See page 36 for procedures for ERASING DIAGNOSTIC
TROUBLE CODES (DTCs) from the vehicle's on-board
computer.
Write the codes down on a piece of paper for reference before
erasing.
3. After the erase procedure is performed, most of the Monitor icons on
the CanOBD2&1 Scan Tool's display will be flashing. Leave the
CanOBD2&1 Scan Tool connected to the vehicle, and perform a
Trip Drive Cycle for each "flashing" Monitor:
Misfire, Fuel and Comprehensive Component Monitors run
continuously and their icons will always be on solid, even after
the erase function is performed.
Each DTC is associated with a specific Monitor. Consult the
vehicle's service manual to identify the Monitor (or Monitors)
associated with the faults that were repaired. Follow the
manufacturer's procedures to perform a Trip Drive Cycle for the
appropriate Monitors.
While observing the Monitor icons on the CanOBD2&1 Scan
Tool's display, perform a Trip Drive Cycle for the appropriate
Monitor or Monitors.
WARNING: If the vehicle needs to be driven in order to perform a
Trip Drive Cycle, ALWAYS have a second person help you. One
person should drive the vehicle while the other person observes the
Monitor icons on the CanOBD2&1 Scan Tool for Monitor RUN status.
Trying to drive and observe the CanOBD2&1 Scan Tool at the same
time is dangerous, and could cause a serious traffic accident.
4. When a Monitor's Trip Drive Cycle is performed properly, the
Monitor icon on the CanOBD2&1 Scan Tool's display changes from
"flashing" to "solid," indicating that the Monitor has run and finished
its diagnostic testing.
If, after the Monitor has run, the MIL on the vehicle's dash is not
lit, and no stored or pending codes associated with that
particular Monitor are present in the vehicle's computer, the
repair was successful.
If, after the Monitor has run, the MIL on the vehicle's dash lights
and/or a DTC associated with that Monitor is present in the
vehicle's computer, the repair was unsuccessful. Refer to the
vehicle's service manual and recheck repair procedures.
The Enhanced CanOBD2&1 Scan Tool is a special diagnostic tool that
communicates with the vehicle's computer. The CanOBD2&1 Scan Tool
lets you view and/or "capture" (record) "real-time" Live Data. This
information includes values (volts, rpm, temperature, speed etc.) and
CanOBD2&1
OBD2 Systems
I/M READINESS TESTING
45