Table of Contents
Advertisement
Connecting the Interface Cables
The Ethernet interface cable from ENET1 to the headend LAN is the only standard
cabling. All other interface cabling is contingent upon the APEX1000 configuration (as
defined by the specific system implementation).
Inserting or Removing Cables
Common F and BNC tools facilitate the insertion or removal of connectors from the
APEX1000. Typical tools are:
•
The "F" connector removal tool from
•
The BNC tool from
CAUTION
To function properly, all RF Outputs must be terminated with 75 Ohms for the internal
RF Power Level detector. Unterminated RF Outputs may trigger an APEX RF Low Alarm.
Installation • Installing or Removing GigE SFP Transceivers
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Techni Tool
Figure 3-3 — APEX1000 front/rear panel I/O cable connectors
Toner
(part number XQT)
(part number 702SC007)
B
35
Advertisement
Table of Contents
