Mapping Error Codes - Motorola APEX1000 Installation And Operation Manual

Mapping Error Codes

Error Code
Reference Number Error Description
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
Status • Reports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
OTS number out of range
OTS already pass-thru mapping
OTS already PID or Service mapping
Max service mappings on OTS reached
Max service mappings supported reached
Max PID mappings supported reached
MR mapping invalid – OTS not in MR mode
Output stream is not active, mappings not allowed
Invalid GigE UDP Port
Input Not Enabled - mappings not allowed
Input IF Port out of range for type
Input Type not supported
Invalid MC IP Address (reserved MC or invalid range)
Invalid Source IP Address (not Class A, B, or C)
Maximum number GigE input streams reached
Maximum number Host input streams reached
Primary input TS is already a Secondary TS
Primary Number of Source IPs per MC IP exceeded (4)
Secondary Number of Source IPs per MC IP exceeded (4)
Secondary on a Primary is already in use when adding sec
Secondary found on another Primary input TS when adding sec
Secondary is not enabled
Secondary is already in use as a Primary input stream
Secondary is already in use on another Primary input
Secondary is exact same stream as Primary
B
242