Table of Contents
Advertisement
RPC Mode Specific Configuration
When the APEX1000 is configured for RPC SDV mode, only the input-output pairing
must be configured through the EM. (This process assumes the RPC session controller
is already configured and operating correctly.)
To configure session control mode specific settings, select SDV > RPC Session
Control.
The RPC Session Control window displays:
To configure an RPC Session:
1. Select a Primary and a Secondary GigE interface for each QAM.
Note: Primary and Secondary interfaces for a transport stream must be either GigE1
and GigE2 or GigE3 and GigE4.)
2. Click Apply to validate these settings in the APEX1000.
Configuring for Switched Digital Video • Step by Step Instructions
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
B
179
Advertisement
Table of Contents
