Motorola APEX1000 Installation And Operation Manual page 165

Item
Index
Enable
Input Interface
Input UDP Port
Multicast IP
Source IP
Input PID (hex)
Output PID (hex)
Disable All
Clear All
Status
Manual Routing • Stream Pass Thru Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Ancillary PID Routing window field definitions
Definition
Index of the PID Mapping Table.
Range: 1 – 128
Indicates whether this PID mapping is enabled or disabled. Once written, the change
to this parameter will only take immediate effect after Apply is clicked.
Click Save to allow this change to persist through subsequent reboots.
Number of the input type from which to obtain data: GigE 1 – 4 or Host 1 – 2
Input UDP port from which to obtain data:
•
GigE: 0 – 65535
•
Host: 1024 – 65535
The Multicast receive IP address:
•
Valid Range: 224.0.1.0 – 239.255.255.255
•
Reserved: 224.0.0.0 – 224.0.0.255
•
Not used: 0.0.0.0
This is the IP address of the source device for multicast reception.
The source IP address must be a valid singlecast address. The value 0.0.0.0 is a valid
entry.
The input MPEG PID to multiplex. The PAT PID, 0x0000, and the Null PID, 0x1FFF,
cannot be mapped as ancillary PIDs.
The range of available input PIDs is 0x0001 – 0x1FFE.
Output PID to use for the data. If PID remapping is disabled, the output PID value
must match the input PID value. When PID Remapping is enabled, the APEX1000 will
enforce a range of PIDs that can be remapped.
The Range of PIDs is outside of the reserved range for services. You can only remap
ancillary PIDs in the following ranges:
•
0x0001 – 0x002F and 0x1C00 – 0x1FFE
You should not map the following PIDs as ancillary PIDs, as they are defined for other
uses in the system: PID 0x1FFB, reserved for the EAS message PID, and PIDs
0x1FED and 0x1FEE, reserved for the RPC mini-carousel PIDs in RPC mode.
Caution: Do not attempt mapping while in RPC mode.
This is an EM function which causes all mappings on this QAM TS to be disabled.
Disables all mappings and resets default values.
Provides drop-list selections to quick status verification of:
•
Input PSI Table
•
Output PSI Table
•
Output Program
•
Output Transport Utilization
•
Input Stream Redundancy
•
Input Stream Status
•
Mapping Errors
B
147