Setting The Operating Mode - Motorola APEX1000 Installation And Operation Manual

Setting the Operating Mode

Access the Operating Mode panel from the
There are four operating modes in the Operating Mode drop-down list:
1. Undefined
2. Session Control:
3. Manual Routing — Operator input controls the APEX, manually routing input
transport streams to designated QAM outputs.
4. UDP Mapping — The sixteen-bit UDP port number on the incoming TS is routed to
a specific output QAM port and output program number.
5. DEPI — In DEPI mode (M-CTMS/DOCSIS), the M-CMTS core performs transmission
convergence and generates the DOCSIS SYNC messages.
CAUTION Changes to the operating mode are only possible if there are no mappings or SDV
sessions to that particular transport stream. Additionally, when you change the operating
mode, you must click Apply to save the settings.
Configuration • Configuring QAM Ports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
RPC — The APEX1000 acts as an edge device that receives and processes
commands from two external sources using the RPC protocol.
RTSP Session Mode — The APEX1000 acts as an edge device that receives
and processes commands and PID remapping using the RTSP protocol.
Output TS Configuration
B
window:
132