Motorola APEX1000 Installation And Operation Manual page 234

Item
TS: QAM
Enable
Remote DEPI ID
Control Connection ID
UDP Port
Sync Time Correction
DEPI Control
Connections
Notes:
1. You can also access DEPI Session Mapping by selecting Output TS Configuration >
DEPI Session
2. You can monitor the health of various aspects of DEPI control connections and
sessions by accessing Status >
3. You cannot modify the session-specific information (Remote DEPI ID, UDP port) if the
corresponding session is active (enabled).
DEPI – MPT Mode • Overview
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
DEPI Session Mapping window definitions
Definition/Range
Identifies the Output Transport Stream.
Select this checkbox to enable the corresponding session.
Logical identification (Remote End ID) for the DEPI session
assigned to the corresponding output transport stream.
Because sessions are configured statically, this parameter will be
used as the session identifier for data messages received from the
M-CMTS core entity.
Identifies the control connection where this session belongs.
If the corresponding control connection has been configured to run
DEPI over UDP, this parameter indicates the incoming UDP port
allocated to this session.
Range: 61696 – 65535
This value should only be modified if not impacting any existing
session.
Note: Only Active if connection is defined as UDP. Must be unique.
Select this checkbox if correction of timestamp value in incoming
SYNC message is required.
Opens the DEPI Control Connections
Mapping.
DEPI Status
configuration window.
and Status > DTI Status.
B
216