Table of Contents
Advertisement
Visually inspect the system for defects prior to starting it.
Make sure the ozone line is connected and the gas to be produced
can be included into the production process and processed according
to its intended use.
Make sure all safety elements are available and activated, and work
properly.
The gas containing piping and valves must be dry after purging and may
not contain any dirt particles. If there is any uncertainty as far as the
dryness of the piping and valves are concerned, carry out the purging
process.
Refer to Chapter Purging the System for Drying Out Purposes.
8.3.1 Starting / Shutting Down the System
To start the ozone system, turn the main switch to position ON.
To shut down the ozone system, turn the main switch to position OFF.
Manual_SMOevoPLUS_eng_01.2019.doc
NOTICE!
NOTICE!
The main switch of the ozone system is located at the side
•
panel of the control cabinet.
By means of the main switch the complete power supply of the
•
ozone generating system is turned on or off.
Manual Ozone Generating System SMOevo
PLUS
Operation
page 79 of 179
Advertisement
Table of Contents
