Table of Contents
Advertisement
12.4 Final System Shutdown
If the ozone system is finally to be shut down, proceed as follows:
1.
Purge the ozone system with dry oxygen or dry air until the lines are free of ozone.
2.
Set the power switch to 0/Off. Depressurize all the piping and system components.
3.
Ensure the external voltage is switched off.
4.
Disconnect all electrical connections from the system.
5.
Disconnect the system from the media supply connections.
6.
Discharge the cooling water of the ozone generator and converter.
7.
Loosen all fastening devices on the wall and floor.
12.5 Disposal of Materials
To protect the environment and for your own safety, observe the following instructions:
Observe all local regulatory requirements regarding the environment.
•
Dispose of materials in a safe and environmentally friendly manner.
•
Separate materials by material types.
•
The following table gives an overview of the materials used for the construction of the ozone
system.
Materials
Galvanized steel
Stainless steel
Copper
Glass
Aluminum
PTFE
Synthetic material
Take the hazardous waste to a local hazardous waste site.
Against payment, disposal can also be done by the Wedeco Service.
Refer to Chapter Contact Addresses.
Manual_SMOevoPLUS_eng_01.2019.doc
Manual Ozone Generating System SMOevo
Skids of the ozone system, electrical cabinet, metal
sheets in the electrical cabinet
Ozone generator, piping, electrodes, valves
Electronic components
Electrodes, inspection window
Metal sheets in the electrical cabinet, particle filter
Seals, hose lines
Cable sheaths, high voltage duct, electronic
components, housing of measuring devices, particle
filter, pipe clamps
Shutdown and Disposal
Uses in
PLUS
page 173 of 179
Advertisement
Table of Contents
