Thermo Scientific Partisol 2000i Instruction Manual page 367

Thermo Fisher Scientific
36. From the list of command codes on the right side of the AK Protocol
Setup screen, select the correct series of command codes needed to
trigger the desired instrument. As codes are chosen, they will appear on
the bottom of the screen in the Connection Command box. If a code is
entered incorrectly, it can be deleted by selecting the code in the
Connection Command box and pressing the Delete key on your
computer's keyboard.
37. The remaining portions of the screen should have been set while
establishing the modem connection. Do not modify these settings.
38. Select "OK" to exit the AK Protocol Setup screen. This will display the
Connection Type screen.
39. Choose "OK" from the Connection Type screen to finish the
connection setup.
40. Connect to one of the instruments by highlighting the connection
name on the Connect List screen
Connection icon on the tool bar. The connection to the instrument
will be initiated and the proper command codes sent. When
communication is established, the instrument's main screen will be
displayed.
Note If the connection is successful, the unit's serial number will be
displayed at the top of the screen. Ensure that the correct serial number is
displayed to verify that the proper command codes were sent and that the
serial port trigger is functioning properly. If the connection is not successful
or if there is no instrument attached, then the serial number area will be
blank or will display "99999." If the modem loses its connection, wait at
least 1 minute before trying to establish another connection. This allows
the modem to reset itself.
41. RPComm can now be used as described in "RPComm" on page D-1.
42. To connect to the other instrument through the serial switching device,
the current connection must be terminated. Enter the proper command
codes for the desired instrument as described above and initiate the
modem connection. If the modem loses its connection, wait at least 1
minute before trying to establish another connection. This allows the
modem to reset itself.
Communications Using iPort or RPComm
(Figure D–20) and select the
▲
Partisol 2000i and Partisol 2000i-D Instruction Manual
Using RPComm
D-35