Thermo Scientific Partisol 2000i Instruction Manual page 51

Thermo Fisher Scientific
Sampler Stand Parts List
A (2) Top front and top back (36-005479)
B (4) Top right, top left, bottom right, bottom left (36-005476)
C (4) Legs (36-005478)
D (2) Bottom front and bottom back (36-005477)
E (4) Hex head bolt 1/4-20 x 3/8" (21-001291-0006)
F (20) Hex head bolt 1/4-20 x 3/4" (21-001291-0012)
G (24) Flat washer, 1/4" (21-001275)
H (24) Split ring washer, 1/4" (21-000848)
IMPORTANT Always remember to place the split ring washer between the
head of the bolt and the washer.
1. Assemble the bottom of the stand by laying out the front, back and
sides (Figure 2–8).
2. Place one leg on each inside corner and fasten with F, G and H
hardware (Figure 2–7).
3. Attach the top front and back to the outside of the legs with F, G and
H hardware (Figure
4. Fasten the right and left rails to the legs and top front and back rails
with F, G and H hardware
5. Tighten all hardware.
6. Place the Sampler onto the stand and secure using E, G, and H
hardware (Figure 2–7).
▲
2–7). Do not tighten.
(Figure 2–7).
Partisol 2000i and Partisol 2000i-D Instruction Manual
Installation
Partisol Stand
2-9