Thermo Scientific Partisol 2000i Instruction Manual page 5

Thermo Fisher Scientific
About This Manual
This manual provides information about installing, operating, maintaining,
and servicing the Partisol 2000i Air Sampler and the Partisol 2000i-D
Dichotomous Air Sampler. It also contains important alerts to ensure safe
operation and prevent equipment damage.
The manual is organized into the following chapters and appendices to
provide direct access to specific operation and service information.
Chapter 1 "Introduction" introduces the user to the advanced features
●
of the Partisol 2000i and Partisol 2000i-D and describes the flow and
sampling configurations of the system. It also discusses the flow control
scheme used in the unit.
Chapter 2 "Installation" describes how to unpack, set up, and start up
●
the Sampler.
Chapter 3 "Filter Handling and
●
handling, exchanging and transporting filters.
Chapter 4 "Partisol 2000i Inlet
●
configuring the Sampler with a variety of inlet systems.
Chapter 5 "Operational
●
modes used on the Sampler.
Chapter 6 "Sampler
●
for programming the Sampler.
Chapter 7 "Sampler
●
characteristics prior to starting a sampling run, programming a
sampling run, and retrieving data.
Chapter 8 "Calibration" provides procedures for calibrating the
●
Sampler and calibration setup.
Chapter 9 "Firmware Screen
●
display screens, the front panel pushbuttons, and the menu-driven
firmware.
Chapter 10 "Preventive
●
procedures to ensure reliable and consistent instrument operation.
Chapter 11 "Troubleshooting" presents guidelines for diagnosing
●
Sampler failures, isolating faults, and includes recommended actions for
restoring proper operation.
Exchange" provides procedures for
Conversion" provides procedures for
Modes" describes the different operating
Settings" describes the different options available
Operation" describes how to verify the Sampler's
Descriptions" describes the front panel
Maintenance" provides maintenance
Partisol 2000i and Partisol 2000i-D Instruction Manual i