About This Manual
FCC Compliance
FCC Compliance
iv
Partisol 2000i and Partisol 2000i-D Instruction Manual
Alert
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note This equipment has been tested and found to comply within the
limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to correct the interference at his or her
own expense.
▲
Description
touching any internal components. When the instrument
is unplugged, the chassis is not at earth ground.
Disconnect the serial cable before changing RS-232 and
RS-485 selection to prevent damage to any connected
▲
equipment.
Do not use solvents or other cleaning products to clean
▲
the outside case.
Do not remove the LCD panel or frame from the LCD
▲
module.
The LCD polarizing plate is very fragile, handle it
▲
carefully.
Do not wipe the LCD polarizing plate with a dry cloth, as
it may easily scratch the plate.
Do not use alcohol, acetone, MEK or other ketone based
or aromatic solvent to clean the LCD module, but rather
use a soft cloth moistened with a naphtha cleaning
▲
solvent.
Do not place the LCD module near organic solvents or
▲
corrosive gases.
Do not shake or jolt the LCD module.
▲
▲
▲
Thermo Fisher Scientific