Thermo Scientific Partisol 2000i Instruction Manual page 314

C-Link Protocol Commands
I/O Configuration
B-34 Partisol 2000i and Partisol 2000i-D Instruction Manual
33 flt2id
34 casid
35 cas2id
36 start
37 stop
38 elap-tm
41 tm
42 tm
43 tm
44 exfg
45 statcode
46 ain1
47 ain2
48 ain3
49 ain4
50 ain5
51 ain6
52 ain7
53 ain8
relay stat
This command reports the current relay logic as normally "open" or
normally "closed," if all the relays are set to same state, that is all open or all
closed. The following example shows that the status of all the relays' logic is
set to normally "open".
Send: relay stat
Receive: relay stat open
Note If individual relays have been assigned different logic, then the
response would be a 4-digit hexadecimal string with the least significant
byte (LSB) being relay no 1.
For example:
Receive: relay stat 0x0001 (indicates relay no 1 is set to
normally open logic, all others are normally closed)
Receive: relay stat 0x0005 (indicates relay no 1 and 3 are set
to be normally open logic, all others are normally
closed)
set relay open
set relay open value
set relay closed
set relay closed value
These commands set the relay logic to normally open or closed for relay
number value, where value is the relay between 1 and 16. The following
example sets the relay no 1 logic to normally open.
▲
Thermo Fisher Scientific