How To Use This Manual - HBM GEN Series User Manual

Daq products (data acquisition system)

Hide thumbs Also See for GEN Series:

Table of Contents

1.1.1

How to use this manual

This manual has been written to help you to benefit as fast as possible from the Master/Slave

option and to get maximum results from its usage.

Many people read their user manual only as a last resort. If you are one of those, the next

paragraphs tell you where to find information when you need it.

IMPORTANT

Read the next section even if you do not read anything else.

Safety Messages

Proper and safe use of this system depends on careful reading of all safety instructions and

labels. Follow the safety procedures in addition to the safety precautions specified in the GEN

series Data Acquisition System and the Perception Data Acquisition Software user manuals.

Read the section "Installation" on page 12 for details.

Master/Slave board

To know how to install, connect and set-up the Master/Slave board in the correct way, read the

section "Master/Slave board". We do not advise you to install and connect the system without

reading this section. This section also describes how to set the software settings in the

Perception software.

Verification

To do an initial check-out and to verify the correct operation of the Master/Slave configuration,

read the chapter "Verification".

Specifications

This section contains technical information about the Master/Slave board and the fiber-optic

cable.

I2710-1.0 en

Table of Contents