Table of Contents
Advertisement
9
In the Settings sheet, go to the Trigger group in the task pane and select Channel.
10 In the Trigger mode column, set all triggers to Off.
Figure 3-3: Trigger mode list
11 Select the input with the connected TTL level, 1 Hertz signal on the master mainframe and
set the trigger of this channel to Basic.
12 In the Trigger group, select Recorder.
13 Double-click on the Master/Slave trigger cell to open it for modification.
14 In the drop-down list that comes up, select Transceive for all recorders.
Figure 3-4: Master/Slave trigger list
15 Set-up a display with the first channel of the first recorder board in the master mainframe
and the first channel of the first recorder board in the slave mainframe.
I2710-1.0 en
33
Advertisement
Table of Contents
