Jb - Disable Top Of Form Backup - Intermec EasyCoder PD4 Programmer's Reference Manual

Chapter —Commands
JB – Disable Top of Form Backup
This command disables automatic top of form backup of the
Description
media.
Syntax
JB
Top of form backup is used in connection with the j command,
Remarks
which makes the printer feed out an extra amount of media after
printing the label, so as to allow the media to be torn or peeled
off properly. It does not work with a cutter.
By default, the media is pulled back before printing the first label
in next batch as to allow the printing to start at the top of the
label, see JF command.
The JB command will disable this function, that is any j com-
mand will be ignored, and the printer will stop feeding when
the end of the label becomes aligned with the printhead's dot
line. However, the j command is kept stored in memory and can
be enabled again using a JF command. To disabled top of form
baclup with a cutter, first send an O command followed by a JB
command.
Example
JB↵
 ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
:Disables top of form backup