Default - Restore Factory Default - Intermec EasyCoder PD4 Programmer's Reference Manual

^default – Restore Factory Default
This command set all parameter back to the factory default.
Description
Syntax
^default ↵
Remark Many recommendations, especially when troubleshooting or
updating firmware, require the need to start from a known
state. This command returns the printer to its default setup.
See Default Setup in Chapter 3, for the default value of setup
parameters. A delay of two seconds should be observed before
inputting other commands as the printer restarts after cleanup to
factory default.
Return to factory default setup.
Example
^default↵
ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
Chapter —Commands
125