Reset Printer - Intermec EasyCoder PD4 Programmer's Reference Manual

Chapter —Commands
^@ – Reset Printer
This command resets the printer.
Description
Syntax
^@
Remarks The ^@ command resets the printer in the same way as a power
off followed by a power on.
• The command must be followed by CR/LF to be correctly
• The reset command is only available during command input,
• The printer will be unavailable for a short time during which
Note: An error report has higher priority than other commands
and is processed directly, both in position of normal command-
input and in position of any error recovery.
An ^@ command cannot be performed anywhere else, such as
• during downloading of images, fonts, or forms, or
• inside a variable-input (?) or inside a string-area (""), or
• when the input data buffer is full (> 8000 bytes).
Example
^@ ↵
124 ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
interpreted.
that is, not as data in PCX-graphics, soft fonts, or in format
forms.
all commands sent to the printer will be lost.
:Printer will be reset.