Spc - Setup Print Copy - Intermec EasyCoder PD4 Programmer's Reference Manual

SPC – Setup Print Copy
This command is used to change the function of the Feed key to
Description
print a copy of the label residing in the printer's image buffer.
Syntax
SPCp
Parameters p
1
The following commands will disable Print Copy when SPC1
Remarks
is set: A, B, b, GW, GG, LE, LO, LS, LW, N, q, Q, r, R, X and
Info. The current SPC value is stored in Flash memory and
printed on the test label.
Example
SPC1↵
ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
1
Setup Print Copy value:
0 Media will feed as usual when the Feed key is pressed (Default).
1 Print Copy is activated, but will be disabled if any of the commands
listed below have been sent since the last printout.
2 Print Copy is activated. In this state, additional fields can be added to the
existing image and printed by pressing the Feed key.
Chapter —Commands
:Print Copy is activated.
101