US – Enable Error Reporting
This command is used to enable the printer's status reporting
Description
feature with optional direct recovery.
Syntax
US[A][B][E]
Parameters
A
B
E
Any or all parameters can be activated at the same time. Refer to
Remarks
Appendix A for information on error types.
Parameters are saved in the Flash memory.
The format of the error messages is controlled by the eR com-
mand.
Example
Command Reply
↵
<ACK>
USABE
↵
(no reply)
eRQ,6,R
↵
(no reply)
N
↵
(no reply)
AA
↵
<NAK>01Q
P
R
/. Reply only works on serial and USB ports.
1
ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
If any error of type A occurs, it will be directly recovered and continue in normal
mode. No stop for recovery, often performed with FEED key.
If any error of type B occurs, it will be directly recovered and continue in normal
mode. No stop for recovery, often performed with FEED key.
Error 13 LTS reply control (label taken sensor). Returns error 13 if LTS detects a
label before and after printing.
Comment
1
Activate all error flags
Setup User-Defined Error/Status Character control to
Q for <XOFF> and <R> for <XON>
Clear image buffer and errors
Erroneous command type A; Syntax error
Print image buffer with error 01
Direct recovery error 01 (type A) and continue
Chapter —Commands
115