Sa - Setup Adjust - Intermec EasyCoder PD4 Programmer's Reference Manual

Chapter —Commands
SA – Setup Adjust
This command is used to control the activation and storage of
Description
setup commands / values.
Syntax
SAp
Parameters p
1
The SA command affects the following setup commands: R, r,
Remarks
D, j, J, q, Q, S, Z, and SPC. The current SA value is stored in
Flash memory and printed on the test label.
Example
SA2↵
100 ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
1
Setup Adjust value:
0 All setup commands remain active and values are saved when
changed. T he printer will use stored setup values (Default).
1 All setup parameters are locked and commands will be ignored. T he
printer will use previously stored setup values.
2 All setup commands within forms will be ignored.
:All of the commands listed above that are called
within forms will be ignored.