D - Density - Intermec EasyCoder PD4 Programmer's Reference Manual

D – Density
This command is used to select the print density.
Description
Syntax
Dp
1
Parameters p
1
The density command is used to control the energy to the
Remarks
printhead. A number of factors affect the actual darkness of the
printout:
• Direct thermal printing or thermal transfer printing
• Print speed
• Different brands of direct thermal media
• Different combination between transfer ribbons and receiving
• Different ambient temperature/humitity
The printed information may also require the density to be
adjusted. Typically, this applies to different bar code orientations
and densities.
Test after the print speed has been set (see S command) and make
further adjustments until you have found the settings which best
apply to your unique application.
Example
D9↵
ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
Density setting (0-15). Default: 10.
0 is the lightest printing and 15 is the darkest.
face materials
Chapter —Commands
:Selects density 9
55