Z - Print Direction - Intermec EasyCoder PD4 Programmer's Reference Manual

Chapter —Commands
Z – Print Direction
This command is used to select the print orientation.
Description
Syntax
Zp
1
Parameters
p
1
This command affects the complete print image, including text,
Remarks
bar codes, graphics, lines, and boxes, as well as the location of the
reference point (see R command).
Note that printing a test label in the Test Mode, or by means of
a U or UP command, will reset the print direction to default (=
ZT).
ZT Command:
ZB Command:
Example
ZB↵
122 ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
Print orientation:
T Start printing from the top of image buffer (default).
B Start printing from the bottom of image buffer.
PD4
Feed Direction
EASYCODER PD4
Feed Direction
:Starts printing from the bottom of the image buffer.
EASYCODER