S - Speed Select - Intermec EasyCoder PD4 Programmer's Reference Manual

S – Speed Select
This command is used to select the print speed.
Description
Syntax
Sp
1
Parameters
p
1
Changing the print speed will affect the blackness of the print-
Remarks
out, which may have to be adjusted using a D command.
Example
S2↵
ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
Speed select value:
0 30 mm/sec. (1.2 inches/sec.)
1 40 mm/sec. (1.6 inches/sec.)
2 50 mm/sec. (2 inches/sec.)
3 75 mm/sec. (3 inches/sec.)
4 100 mm/sec. (4 inches/sec.) Default
5 125 mm/sec. (5 inches/sec.) 203.2 dpi (8 dots/mm) printers only.
6 150 mm/sec. (6 inches/sec.) 203.2 dpi (8 dots/mm) printers only.
:Sets the print speed to 50 mm/sec. (2 inches/sec.).
Chapter —Commands