Default Setup - Intermec EasyCoder PD4 Programmer's Reference Manual

Chapter —Setting Up the Printer

Default Setup

Parameter
Error/Status Char.
Density
Character Set
Top of Form backup JF
Media feed adjust
Options
Char. substitution
Form Length
Label Width
Reference Point
Print Speed
Date Format
Time Format
Reply character
Error Handling
Windows Mode
Serial Port
Print Direction
Printhead Resolution Measures
203.2 dpi printheads
300 dpi printheads
The setup will be reset to default values if the Cancel key is pressed more
than 3 seconds in the Dump Mode.
14 ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
Command Meaning
eR0,0 XOFF/XON-handling
D10 10
I8,0,001 8 bits, code page 0, country code 001
Enabled
j136 136 dots (at 203.2 dpi)
j204
204 dots (at 300 dpi)
ON,D
LTS disabled, DT mode, reverse gap disabled,
cutter disabled
oR No substitution
Q24,0
Continuous mode, print gap 24 dots
q832
832 dots (at 203.2 dpi)
q1208
1208 dots (at 300 dpi)
R000,000
X:000;Y000
S3
75 mm/sec. (3 inches/sec.)
TDme/dd/Y4
For example JAN/15/2004
TTh:m:s
For example 13:25:00
UC0
None
US
Error reporting enabled
WN
Disabled
Y96,N,8,1
9600 baud, no parity, 8 data bits, 1 stop bit
ZT
Start printing at top of image buffer
203.2 dpi (8 dots/mm) in both directions
300 dpi (11.81 dots/mm) across the media path
304.8 dpi (12 dots/mm) along the media path