Intermec EasyCoder PD4 Programmer's Reference Manual page 93

The following table illustrates the results of some combinations of
the various O command parameters:
Command
O
OD
OS
OD,S
OS,Cnnn|b
OD,S,Cnnn|b Enable
ON
ON,D
ON,D,S
ON, Cnnn|b
OCnnn|b
OD,Cnnn|b
Example
ON,D↵
ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
LTS (N) DT/TTR
Mode (D)
Enable TT Mode
Enable DT Mode
Enable TT Mode
Enable DT Mode
Enable TT Mode
DT Mode
Disable TT Mode
Disable DT Mode
Disable DT Mode
Disable TT Mode
not used TT Mode
Disabled DT Mode
Chapter —Commands
Reverse Cutter (C)
Gap (S)
Disable Disable
Disable Disable
Enable Disable
Enable Disable
Enable Enable
Enable Enable
Disable Disable
Disable Disable
Enable Disable
Disable Enable
Disable Enable
Disable Enable
:Enable DT Mode
:Disable LTS
:Disable reverse gap sensor
:Disable cutter