Pf - Feed Media; Esim V5.12 For Easycoder Pd4-Programmer's Reference Manual - Intermec EasyCoder PD4 Programmer's Reference Manual

PF – Feed Media
This command is used to feed the media forward or backward a
Description
given length.
Syntax
PFp
Parameters p
1
p
2
p
3
Media feeding is disrupted by pressing FEED-key or by opening
Remarks
cover.
The following command will feed the media forward 360 steps,
Examples
make the printer detect gap/black mark before next print job,
and cause a delay of 3 seconds after the feed. Red LED will blink
during the delay.
PF360,0,30↵
The following command will retract the media 360 steps, and
assume that the media is in printing position.
PF-360,1↵
ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
[,p [,p ]]
1 2 3
Numbers of steps to feed the media. Positive values will feed the media for-
ward, negative values backward. Range -999 to 9999.
Position control after feeding. Allowed values:
0 = The media has unknown position. Printer needs label gap/black mark
detecting before next print job (default).
1 = Media is located in printing position.
2 = Media feed will stop when Black mark/label gap is in sensor position or,
if no black mark/gap is detected, when p
be reported).
Optional delay after feeding. Delay will be p
Chapter —Commands
dots are stepped (and errror 99 will
1
* 100 ms.
3
1