F - Cut Position - Intermec EasyCoder PD4 Programmer's Reference Manual

f – Cut Position
This command is used to adjust the cutting position along the
Description
Y-axis in relation to the media according to characteristics of
individual printers and batches of media.
Syntax
fp
1
Parameters p
1
When using labels on liner, the printer will advance each printed
Remarks
label to the cutting position (between two labels) according to
the program before the liner is cut. Due to differences between
batches of media, the printer may not cut exactly between labels,
but either cut a slice at the last part of the printed label or a slice
at the front part of next label.
Cutting through labels should be avoided, because the adhesive
will stick to the cutting parts and prevent them from operating
properly.
If the cut occurs in the already printed label, increase the cut
position index value.
If the cut occurs in the next label, decrease the cut index value.
Example
f110↵
ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
Cut position index measured in dots:
203.2 dpi (8 dots/mm):
Recommended: 070–130.
Min/max: 020–180 (lower or higher values ignored).
Default: 100
300 dpi (11.81 dots/mm):
Recommended: 050–150.
Min/max: 000–200 (lower or higher values ignored).
Default: 100
:Increases the cut position index value.
Chapter —Commands